AGRI-COVER Command-10 Manual de Instalação descarregar pdf (Página 21)

STEP 19

Attach remote control box bracket to a rigid location on trailer near

electric hopper motor. Align remote control box, terminals down, with

pre-drilled holes in bracket. Secure using bolts, washers, and nuts

provided.

Select most suitable route for wires usually along frame with existing

harness. Run heavy gauge wire from rst remote control box to

second remote control box. Prep wires by stripping off insulation as

needed. Slide heat shrink over wire, attach ring terminals and apply

heat to shrink tubes. Slide wire through rubber boots on rst remote

control box and attach wires to terminals on rst remote control box.

At second remote control box slide rubber boots over wire and attach

to terminals. NOTE: When tightening nuts on terminals always

hold base nut when tightening top nut. Do not over tighten. (see

Figure 19 on page 22).

Run heavy gauge wire from remote control box to electric motor

terminals. Prepare wire ends for motor terminals with heat shrink

tubes, 5/16” ring terminals, and rubber boots. Attach BLACK wire

to terminal 1 on motor. Attach RED wire to terminal 2. Always hold

base nut while tightening top nut. At Battery, rst attach RED

wire to (+) positive post. Then attach BLACK wire to (-) negative

post. Check power by activating switch to open position and closed

position. When done, make sure all connections are secure and all

wires are clear of sharp edges. (see Figure 19 on page 22).

WIRING ADDITIONAL ELECTRIC HOPPER BOTTOMS

Test operation. If motor runs Hopper in reverse of open and

close positions on switch, reverse wires on motor terminals.

1 2 ... 16 17 18 19 20 21 22 23 24

Sem comentários

AGRI-COVER Command-10 Manual de Instalação Página 21